The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
Update: I went ahead and took my chances by buying this motor. I paid $235 and it came with a supposed dead battery that is actually a good battery which is a plus. I can post any pictures requested if it helps diagnose any issues. I plan to start by just tearing the old wiring harness out and...
Thanks, I won’t be spending $1,000 on a motor. What I might do is offer the seller $100, take the other $200 to make my Chrysler watertight and running, then sell the Chrysler for a lot and use that money to fix the Johnson. That’s reliant upon the seller selling it that cheap though. I’m just...
I’ve found a few other motors around $1000 but they have to be sold with the boat and I just can’t do that. Some others are available but they are too big. I can only use a 60hp on my Polarkraft boat. I’m located in Decatur Alabama 35601. I’m willing to drive up to 200miles if needed. But that’s...
So the air silencer is actually included, the current owner took it off thinking all this needed was a carb tuneup. I’m going to order a bite camera and see if I can maybe find any rust in the lower unit. Unfortunately the bottom screw was missing. I know I’ll definitely need the new harness...
Update: I have attached more pictures to try and verify the condition of the motor. I looked at it today, and well, the results weren't too good. What do y'all think? I haven't bought it yet but would still like to. Unfortunately, all wiring is gone and several throttle linkage connectors...
Understood... I hope there isn't any, this is one of the best deals on a motor in my area I can find, it's exactly what I need and the seller is honest and friendly. My Chrysler had water in it and I've deemed it uneconomical to repair. Chances are the bearings and gears are going bad or trashed...
Good evening to all and a big thanks to everyone who's participated so far. I just wanted to provide a quick update on the current situation. I spoke with the owner today, and I will be looking at this motor on Wednesday, there is a chance of rain, but I'm going to ignore that and hope for the...
I'll be sure to keep this thread updated if I purchase this motor. I comp tested my Chrysler and the upper cylinder is bad, pulling 74Psi and the lower is pulling just over 100. I've read a few other posts about comp tests compared to mine, and the top definitely has issues and the bottom is...
Thank you all! I appreciate all of the helpful feedback. I was searching for replacement parts just to get an idea of what I might be getting into, replacement solenoid system is $250 brand new from the manufacturer. So I will a check operation and go from there. What is y’all’s opinion on...
Awesome, I’ll be sure to check the shift conditioning. What are your thoughts on the wire condition? Is that something easily replaceable? I should have plenty of wire, I have some 12,14,16 gauge wire and I also have some of that fiberglass heat shielding to go over the wires if you think I’m...
Good evening all, I'm a new member to this forum and will likely be very active here for a while. I'm finally working on my project boat and have lots of questions. My question is: Should I purchase this used 1969 Johnson 60HP motor? I've attached two photos of the motorhead condition, I see a...
