The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
The rod bearing on the number one cylinder siezed up last weekend and scarred my crankshaft pretty good. Does anyone have a crankshaft that would fit or know where I can get a used one fairly cheap? Due to this motors age I am not going to invest a lot of money into it. Any help is appreciated...
I have replaced the old 4 wire plugs on my trailer and Bronco. I have tail lights and turn signals and brake lights. Here is the problem. When the trailer lights are on and I hit the brake, all of the tail lights go off on the trailer and i have no brake lights on the trailer . I have ran new...
I have read posts on timing these motors and it says to run at wide open throttle in gear using a test wheel. I understand the test wheel has very little pitch if any. Is it possible to remove the prop and run it at the dock and achieve the same results? Any replies are appreciated.
I rebuuilt this motor two years ago and it is running great,always ran non synthetic oil. All this reading about synthetic has my curosity up. Would it hurt this engine to run synthetic blend ? Am curious because of what I have read about less smoke and smoother idles.
Could use some advice on the proper wiring of the rectifier for this motor. Where do the three color coded wires go, red, yellow, white? My helper disconnected and has abandond me. Also does anyone have a used one that works?
There is a hose that comes out of the lower unit by the shift rod that comes straight up and goes over the tilt tube and ends in front of the engine. This is a factory hose and it is capped off at the end in front of the engine. Mine is cut in half after it looks like it go pinched. What is this...
1985 suzuki dt-115 with mikuni carbs.<br /><br />One of my carbs has developed a fuel leak, It looks like it is coming from the fitting that connects the fuel hose to the side of the carb. It appears to be leaking where this fitting goes into the carb. Does this fitting screw in or press in? Is...
I have a 1985 Suzuki DT-115 with a slight problem. The hole on the lower unit where the oil drain plug screws in is stripped out to the point where the plug will barely catch and hold. I talked to a local dealer and ran past him a couple of options for a repair. I am looking for oponions from...
