The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
I'm at the point where I believe a need to replace the lower shift cable on my Pre-Alpha Mercruiser 260. I have the common "dies when put it in gear" symptom and it appears the lower shift cable is almost always the culprit. While I am up in there screwin around I may as well replace all the...
Again, I am working on a newly acquired project boat. A Service Manual has been ordered but I haven't received it yet.
This is a picture of the underside of my outdrive. On the port side there is a hose that is about 1" diameter and dead ends. I assume this is the hose from the raw water pump...
Again, I purchase a project boat and going through a few things.
I pulled the lower unit on my Pre-Alpha Mercruiser to replace the impeller/water pump. When I pulled the lower unit down and out of the drive shaft housing this part came down with it. I can't find the part on any schematics. What...
I have acquired a project boat w/ a Mercruiser 260 and Pre-Alpha outdrive. I am troubleshooting power tilt/trim issues.
As an FYI, I have replaced the o-rings and filled with fresh oil in the trim pump.
Mechanically the pump appears to be fine but I believe I have electrical issues. The unit...
I know this has been covered in the past but would like some reassurance. On motors with the Prestolite (blue) ignition, are all components (stator, trigger, coils, CDI boxes) interchangeable from a 4 cylinder (120/125HP) to a 3 cylinder (85/90HP) motors?
Thanks in advance!
I sold off my boat w/ 90HP Force motor this weekend. I still have an almost complete outboard that I purchased for parts. I assume Ebay and CL are the best places to dump them?
I sold off my boat this last weekend and now will begin the search for a upgrade replacement. I haven't been boatless in over 15 years and haven't been boat shopping in almost 7 years. I feel a little incomplete with the hole in the driveway.;)
I have a 906x91c that is having issues at high RPM cruising on the water. At high RPM the motor misses intermittently and it appears to get worse as the motor gets warmer (this might be my imagination). This miss doesn't impact the ability to maintain overall speeds and the boat is still...
