Search results

  1. F

    Rebuild time??

    I have an evinrude 150hp 1989. It runs fine with mufss, but dies in the water as soon as a load is put on it. I ran a compression check. Left middle cylinder is showing 15 psi. all others are around 85 which seems low. my question is where do i go from here?
  2. F

    fuel pump or power pack??

    1989 150hp Evinrude. The motor runs in the yard just fine. As soon as it hits the river or lake, it dies under load. I have cleaned carbs, changed plugs, changed fuel filter, primer bulb, and cleaned the fuel filter. I am suspecting a fuel pump or power pack, but am not sure
  3. F

    Evinrude 150 wont run in the water

    I have an 89 Evinrude, I just overhauled the carbs. The motor runs like a scalded ape in the driveway with the boot. as soon as it hits the water it acts the fool. If i put it in gear the boat dies. With the warm-up lever it runs good. I have replaced fuel filter, primer, plugs, gas, cleaned...
  4. F

    Evinrude powerloss under load

    I have an 89 Evinrude/ 150hp that i let set-up all winter with old gas(i know not good), So first trip out this year i changed fuel primer, fuel filter, and cleaned the fuel pump. The engine will start and run fine using the warm-up lever. As soos as i put the boat in gear it stalls and dies. I...
  5. F

    1989 Evinrude 150 tilt trim motor

    I have just replaced the t/t motor, it works, however while ops checking the unit before putting back on my boat. nothing is moving, the motor spins but the tilt cylinder does nothing. Any suggestions???
Top