Search results

  1. C

    winch wiring

    anyone know how to wire a a winch to go in reverse and forward with two solinoids.
  2. C

    alignment

    what would be the prefered way of alignment of an inboard diesel to a jack shaft. lined up within 1/16 of a inch at the flange or 1/2 inch out of alignment (so the joints in the jack shaft can "wear in") i have always aligned them within .004 in. i have a customer that i have installed a new 41...
  3. C

    stalling

    i am working on a 1996 9.9 rude.it went to a dealer for no water out the pee hole,they replaced the impeller and two other parts that i only have the # for 432453 and 386084.<br />the engine ran well before and now it will not idle. i found spark jumping from power pac to ground,wrong spark...
  4. C

    big horse power

    I have a 1969 swdewinder that i picked up (from a farm field) with a alpha 1 and no eng any one have a idea on how much horse power an alpha 1 will take?
  5. C

    diagnostic help

    I AM WORKING A 2001 90 HP YAMAHA 2 STROKE<br />THAT STALLS WHEN YOU PUT IT IN GEAR,<br />WENT THROUGH TESTS IN MANUAL, I AM DOWN TO<br />THE IGN CHARGE COIL. THERE IS NO VOLTAGE CHANGE <br />FROM CRANKING,IDLE OR 3500 RPM ON THE OUTPUT OF<br />THE CHARGE COIL. IT STAYS AT 5.3 VOLTS AC.<br...
  6. C

    counter rotation

    Can someone please tell me what mades a merc leg<br />left or right rotation.
  7. C

    oil injection

    any thoughs on disconecting oil inj and going to mixing 50:1 on a dt85. it works now but i have heard it could give me a problem as it gets older
  8. C

    electrical problem

    yamaha 90 trla stalls when you put in gear,unplug the computer from the crank sensor and it does not stall. does this mean the cdi,crank sensor or ??<br />thanks in advance
  9. C

    MODEL NUMBER

    1972 BOAT WITH A 250 CHEV ENGINE<br />OMC ELECTRIC SHIFT<br />ANYONE KNOW WHAT MODEL NUMBER THE<br />LEG COULD BE ?<br />I WANT TO ORDER A GASKET SET<br />IT'S BETWEEN A 1968 TO 1972 FOR ONE SET <br />OR A 1972 TO 1986 FOR THE OTHER
  10. C

    NOISE FROM POWERHEAD

    1998 115 MERC 2 STROKE.<br />WAS TOLD IT RAN OUT OF OIL<br />IT RUNS GOOD BUT SLIGHT TIC NOISE<br />FROM THE POWERHEAD. <br />I DO NOT KNOW IF THIS NOISE IS CRANK<br />OR IS NORMAL. SHOULD I TEAR IT DOWN ?<br />ANY THOUGHS ? :cool:
  11. C

    Repower

    I have a 1970 harkin marine olds 455<br />its bolted up to a velvet drive then into a<br />vee drive. The motor is junk (frost cracked)<br />i have a good 260 merc (350 chev)complet and running will the bell housing mate up?<br />anyone know?
  12. C

    smoke

    working on a yamaha 1992 9.9 and it will not start without major choke (covering the carb with a rag) and then major smoke all the time. mix is good,any thoughts?
  13. C

    WEIGHT

    CAN SOMEONE TELL ME THE WEIGHT OF A 85 HP SUZUKI :confused:
  14. C

    STALLS

    I HAVE A 1979 850 MERC 4 CYL THAT STALLS IN GEAR AND IS VERY HAD STARTING. REBUILT CARBS,NEW SWITCHBOX,REBUILT FUEL PUMP,HAS GOOD SPARK. I WAS TOLD THAT I HAVE TAPPERD CYLINDERS.CAN ANYONE FILL ME IN ABOUT THIS PLEASE :confused:
  15. C

    ign question

    Testing a ign system on a 7.5 merc,ser #A105665. I have 240 vdc on 1 coil and 90 vdc on the other, Triger,stator and coils test good. The eng will not fire on the #2 coil am i right to think that the switchbox is at fault :confused: any thoughs :cool:
  16. C

    milky exaust

    can someone please tell me what it means when,<br />the exaust comming out of the prop of a outboard is milky white. (50 hp merc) :confused: <br />ps,it is not from lower unit.
  17. C

    2001 25 bigfoot

    I have a 2001 25hp 4 stroke, after 5 min of good running it will only idle. It cools down and will go for 5 more min. can anyone help. I think it may be the ecm? :p :D
  18. C

    Wirring

    can someone tell me where i can get a wirring diagram for a 115tlrs/6e5/397176. What happend was i was putting a new steering cable in and i unpluged all the wires from the engine. When i went to hook them up the wires for the oil injection were keyed the same. I do not want to hook them up...
  19. C

    warning module

    Can someone please help me test a warning module.<br />It is off a 40 hp 4 cylinder merc,the two blue wires were hooked up wrong. One was going to one side of the oil leval switch, the other blue wire was going two a red wire???<br />I took it off to test but i can not find a test for it. It is...
  20. C

    year of eng

    how can i tell year of engine ser# is 0c187207 it is a 40hp merc
Top