Search results

  1. J

    1995 200HP Evinrude head removal ??

    In order to chase down a cooling problem I have been having, I am ready to pull the heads off my engine to inspect the water passages. Never having done this before, is there anything i need to know before hand? I will use new head gaskets and a torque wrench when putting the heads back on but...
  2. J

    95 200HP Evinrude overheats

    I have an on-going issue with this engine overheating. I had problems earlier this year that a new water pump impeller took care of but the problem is back. Unfortunatly, the slip I am in now is very shallow. Just about every time I start the engine, it sucks up some thick, black mud from the...
  3. J

    Oil filled hubs /bearings ?

    I saw an article recently about bearing hubs filled with heavy oil rather than grease. They have clear plastic caps that allow you to see the oil within. Can I remove my "bearing buddies" and replace them with this new device? Or would I have to replace the entire hub to go to this new system...
  4. J

    '95 Evinrude 200 HP Overheat

    Last weekend, I was making my way down my canal to go out for a quick ride. While doing around 900 RPM's or so, my warning horn started blaring a solid tone (Overheat)I looked at the water preasure gauge and it showed only about 2 psi. Luckily for me, I was right near my ramp. This is the start...
  5. J

    95 Evinrude 200 HP low water preasure

    I just finished replacing the complete water pump in my 200 H.P. Evinrude engine. After reassembly, I connected my garden hose to the flush port and turned on the water. The preasure gauge at the helm only shows approx. 3 psi of water preasure with the engine off. Lots of water is running out...
Top