Search results

  1. H

    Sea King 9hp (clinton) my latest problem

    well this is a 78-79? clinton made sea king ---K900 6106A / 1420554 / XTV S2309A. it started slipping out of forward gear and quickly lost it alltogether, so i opened the lower unit and and found the worn parts, no i did not replace them and yes i know it is the obvious best choice if i can...
  2. H

    Sea King 9hp (clinton) my latest problem

    well this is a 78-79? clinton made sea king ---K900 6106A / 1420554 / XTV S2309A. it started slipping out of forward gear and quickly lost it alltogether, so i opened the lower unit and and found the worn parts, no i did not replace them and yes i know it is the obvious best choice if i can...
  3. H

    Sea King (clinton) 9 hp

    well i have a 78/79? clinton sea king model k900 6106A / 1240554/ type XTV 52309A. im trying to find a carburator that will replace the one thats on it which is an obsolete Walbro LME - 55, ive located some rebuild kits that will work, but while looking for those ive also found alot of new...
  4. H

    sea king k900 issues

    Sea king- (Clinton Mfg) k900 5106A XTV 52309 A the whole throttle assembly was loose as it goes under the flywheel and attached to the drive shaft and i located a brass screw that seems to tighten it, this screw has a hole in the center and a spring behind it. Sure wish i had a manual then...
  5. H

    loose throttle assembly? sea king

    i recently noticed that the throttle was sticking about half way , so started looking and it seems really loose in the motor where it attaches inside under the flywheel? it will go full throttle if i lift up on the plate, it clicks up over something and will be fine. also something seems to...
  6. H

    couple ?'s on 9hp clinton sea king

    I recently got a sea king ( K900 5106 A ), late 70s i guess. anyway i really dont know anything about boat motors, but i figure as far as they go these old ones look pretty simple . so, it was running ok and hopefully still will be once i put it back in the water. ok as in i guess its normal to...
  7. H

    outboard burning ALOT of gas....

    i have a yamaha 90hp 2 stroke 04' on a 20ft skiff, it has been sucking down around a gallon per mile.. other than fuel consumption it runs fine, this is all at around 30 rpm. ive changed the plugs, carbs look clean to me , and installed a new prop.. still what seems to me to be terrible use of...
Top