Recent content by xagneovox

  1. xagneovox

    New trim motor runs but pistons dont move.

    Hello, Recently i posted a post about my manual trim " Hello, ​​​​​​Recently my trim pump went dead, I have put my motor up with the manual release vaulve and with the bracket. Now when I want to put my motor back down, it only goes down to the end of the tilt. How can I lower the two trim...
  2. xagneovox

    Trim manual lowering

    Hello, ​​​​​​Recently my trim pump went dead, I have put my motor up with the manual release vaulve and with the bracket. Now when I want to put my motor back down, it only goes down to the end of the tilt. How can I lower the two trim pegs, they are completely in the up position, I have no idea...
  3. xagneovox

    Johnson 90hp vr0 1989 powertrim

    Hello peeps, The power trim of my motor stopped working while I was bouncing on the waves. When I try at the helm or motor I hear the relais clicking. I measured the voltage just before the trim motor and 12V comes thrue. (blue and green wire). Is there more wiring to check like a ground...
  4. xagneovox

    New outboard, from 2 stroke tot 4 stroke

    Hello, Currently I own a 15 ft speedboat with a v shaped hull equiped with a 90 hp johnson made in '94 (2 stroke). I'm thinking in buying a 4 stroke, I'm currently looking to a yamaha 115 made in '00. The main reason of changing is fuel consumption, smell and sound. Will there be a big...
  5. xagneovox

    Johnson 90 hp powertrim problems (clicking)

    Hello, Yesterday I was cruising on choppy water and halfway my destination I noticed my trim was not working anymore. When I operate the trim on the shifter or on the motor I only hear a clicking noise of the relays. I already tried cleaning the contacts of the relays and manually check all...
  6. xagneovox

    New fuel gauge and sender but gauge peggs to full

    Hello, Recently I bought a new fuel gauge and sender. In the shop they told me that the gauge and sender are good to use with each other with the resistance. When I tested the sender, connected to the gauge it worked like it should. Now installed when I turn my key the fuel gauge peggs over...
  7. xagneovox

    Fuel gauge wiring

    Hello, I'm currently installing a fuel gauge on my fuel tank and I'm having some problems. There are 3 connections on my gauge. 1) "i" -> for this one is use the same one from my tacho 2) GND -> this one I connect to my - from my battery 3) S (sender) this one I connect to my fuel...
  8. xagneovox

    Tacho & fuel gage installation Johnson 90hp 4 cyl. vro

    Hello, I would like to install a tacho in my boat. The tacho is not that hard with the Brp 174732 plug to my motor but is it possible to install my fuel gauge on the same plug so it will only get power after the ignition? Regards,
See more
Top