I have assembled back my motor and gave it a run in a tub of water. It seems like the problem was a clogged pilot hole. Everything thing seems to be working. The only thing I am worried about is the temperature it takes to open the thermostat. I have watched it cycle and felt the piston casing...
I have checked my impeller, thermostat and cleaned out the pilot water hole, now before I put everything together again is there any tests or checks I could do to the cooling system to find out a possible cause to why I don't get a steady stream from my pilot hole or any other cooling system...
I have disaasmbled my lower unit and have looked at my impeller. The fins are still intact but they are bent in different ways, that is two are straight and a couple of the others are bent into a helical position. I tried turning it and it will not budge. Is it good or not? I'm trying to find...
I have a loss of water pressure coming out of my pilot water hole. This is not the first time it has occurred. I cleaned the carb and plugs because the first time the carb was letting out to much gas and it worked o.k. this time I tried it and it didn't work. When on the water I tried bouncing...
I have an intermitent problem with water coming out of my pilot water hole. It does not come out at its regular rate (if at all) , but it seems extra water is coming out of the water discharge hole. The motor is running a little rough but it seems to go just fine. I've once cleaned the carb (do...