**Please read all the steps before beginning this job, Also be very careful not to damage the shift shaft or the drive shaft while doing any of these steps**
Hi there,
I just thought I would share with those do it yourselfers what I did in order to get my seized shift shaft bushing out of a...
could you please point me in the right direction. there is water in the gear oil after only 15 minutes, I thought i replaced all the seals but I feel like there should be something above the bearings but below the water pump base
Drive shaft seal...
First of all,
Thank you very much for the input, All fantastic suggestions.
I am not too familiar with this poppit pressure valve however i will do some research and look into that
A quick update,
yesterday I took all the new gaskets out and redid them all with form a gasket, just incase the...
Hi there guys,
New to the forums here,
I have searched through forums for 4 days and still cant find anybody with this issue.
My engine is a 1980 mercury 115hp inline 6.
I purchased the motor and it needed a bit of work.
I replaced carbs and everything in the top end of the motor, Finally got it...
