FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
The carbs were solvent cleaned (don't have an ultrasonic cleaner) twice. I will take them apart again and this time use a remote tank to get it running while I take steps to clean the on board tank since it must be getting dirt from the built in tank.
I have replaced the jets gaskets and orings...
I.will add the bottom carb idle is all the way tightened and still idles too
Recently I had a full leak out the small silver choke cover on the side of the carb. I read this leak could be from a clogged main jet. Looks like I'm taking the carbs apart again.
I ordered another fuel water...
BF40A Sn BAYL-2000515
Had some bad gas so I cleaned the carbs and replaced main jet #92 99101-ZV5-0920
as well as jet set 16150-ZV3-000 and seals and gaskets.
I don't know if my BF 40A sn BAYL-2000515 wants an initial 1 5/8 turn out on the new replaced pilot screws or 2 1/4.
The service manual...
BF40A Sn BAYL-2000515
Had some bad gas so I cleaned the carbs and replaced main jet #92 99101-ZV5-0920
as well as jet set 16150-ZV3-000 and seals and gaskets.
I don't know if my BF 40A sn BAYL-2000515 wants an initial 1 5/8 turn out on the replaced pilot screws or 2 1/4.
The service manual...
