Recent content by vanrebl

  1. V

    honda 45 hp trim stuck on in down position

    I was out fishing pulled anchor and began to take off when my motor came up out of the water on its own,i shut of motor and pushed down a bunch of times on the trim at the controller and finally it went down. i heard the trim motor still running after the motor went all the way down.the only way...
  2. V

    9.9 merc running rough

    i have a 2003 9.9 merc 4 stroke and to start i have to full choke and keep pumping the bubble (on motor not one in the line) to keep it running . After it warms up it still doesnt run very well at low idle any suggestions thanks vanrebl
  3. V

    merc 9.9 hard to start

    i have a 03 four stroke 9.9 merc manual start .... the problem is when i start it i pull the choke and pull a few times and it fires but i have to keep pumping the bulb on the motor (not on gas line) to keep it running until it warms up and then it dosnt run that great some days better than...
  4. V

    smokercraft drain holes question

    Hi all, i have a 1992 smokercraft 162 promag 45hs honda outboard in the back of the boat i have 1 drain plug hole,2 threaded plastic tubes that stick out (pumps for my 2 live wells) then i have two more holes with plastic beauty ring they look the same as my bilge pump exit hole only a little...
  5. V

    1992 smokercraft promag

    i just reciently bought a 1992 Smokercraft Pro Mag 161 i think dont know the difference between the 161 and 162 anyway i am looking for an owners manual for it....any suggestions .... yes i tried smokercraft...lol javascript:void(0)<br /><br /><br />thanks <br />vanrebl
See more
Top