FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
I have a pair of G Cat pontoons and the three cross members that connect them which when connected they will be 8 feet wide. I am thinking of building a deck on top of them!!! They are 16.5 feet long and they were free. I think I need some additional flotation so am thinking of using my old but...
I replaced the bearings, races, and seal with a kit I bought at TSC(Tractor Supply Company) I drove out the old races and installed the new races and am sure I got both seated. I packed the new bearings per the old standard method of grease in the palm and forceing the grease up into the...
I have a 1976 Mercury 110 9.8 hp I am trying to restore. I need a source or a good substitute for what mercury calls a blanket. This is material that goes on the inside of the upper cowl. I also need what they call the seal which is made of rubber and goes around the inside edge of the cowl...
My kill switch on my mercury 110 9.8 hp had the wires completely corroded off at the switch body and the copper cup under the rubber bulb was detached because the small stud part that the cup attached to was corroded through. I cleaned out the small corroded stud out of the pocket of the rubber...
