FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
I believe the noise started after I noticed water in the oil after overheating. I fixed the water issue. Is there internal damage because of water in the oil
Here is a picture of the rear engine mount bolt. Both sides look the same and it appears to be backed out. This side looks to be out farther than the other side. I'm guessing it shouldn't be like this?
Thank you for all of the suggestions. It sounds like it's coming from the front of the motor. I have not tried to run it without the belt on but that was suggested by someone else so I will try that this weekend. I will also check the motor mounts as I have seen other posts about this causing...
I have a knocking noise and can't determine where it's coming from. Little history - I had the lower unit impeller go bad and it over heated the engine. I pulled the head and had it checked because water was getting in the oil. Head checked out good and I replaced the head gasket of course...
I have a knocking noise and can't determine where it's coming from. Little history - I had the lower unit impeller go bad and it over heated the engine. I pulled the head and had it checked because water was getting in the oil. Head checked out good and I replaced the head gasket of course...
