Recent content by tondss

  1. T

    Going nuts! 75HP chrystler ignition issue. Please help

    Hello my name is Tony I have a year 83 75 HP chrystler outboard model number 758H3F. We lost spark on Oct. 8. I replaced the CDI box with a power pack from cdi model number 115-3301. We also replaced the distributer wheel. Went to start it no spark. So then we changed the trigger eye inside the...
  2. T

    198x Chrysler tilm & trim going slow. Please help.

    Hey guys. I just purchased an 84 bass track. It has a 75hp chrystler on it. I checked the trim on it last night and it worked perfect! Then I took it to my mechanic to have some motor work done. I have a (transom saver ) boom stick that hold motor while driving. My mechanic told me to go up on...
  3. T

    18hp Johnson wont shift into gear after impeller change

    ok guys I did an impeller change on my motor and I went to zip it all back up to find it wouldnt shift into gear. everything is in the right place as far as i know. The impeller hose is hooked up the rod linkage was hooked up good. I noticed if a loosed up the lower unit to were there was a half...
  4. T

    18hp Johnson lower unit water in oil ? help...

    OK so the pic is a bit blurry. Water is coming in from somewhere and I can't fine it pic below is what the oil looks like after I changed it 2 weeks ago.
  5. T

    Evinrude gas tank leak normal? (pic inside)

    o the housing for my tank is leaking the motor hasn't been running correctly due to gas or spark. So I'm eliminating one thing at at time. The flat head is pointing where the air will seap out when squeezing the bulb.
  6. T

    18hp Johnson fuel issue? (video inside)

    OK the carb has been cleaned. The fuel pump is pumping fuel. The idle screw is one turn out the high speed screw is 2 turns out. I have made minor adjustments to the screws to help it run better. But for the life of me I can't get this motor to run right. Please see the video I made...
  7. T

    18hp Johnson fuel pump shim placement?

    Hello fellow boaters! I'm looking for someone's help in placing the shims and springs in the right place. One spring seems a tad bigger then the other both shims are the same. Attached is a picture. What did I do wrong. My motor does not want to idle. The carb has been cleaned and rebuilt. The...
See more
Top