Getting ready to go fishing tomorrow, wouldn't you know it I found a pin sized hole in the right hand side of the foot. Does anybody know how this could of happened? Could I put some gorilla tape on it and get it fixed after I go fishing, or should I sit this one out and go to the mechanic...
I recently purchased a 1995 neptune 180 cc. This boat came from the factory as a one battery boat, what I mean by that is all electric devices ( including tilt and trim bilge etc) are connected to a single battery. When I installed a 55lbs thrust trolling motor I thought it would be a good...
I currently own a 1995 Evinrude 90 horse motor, I am always looking for spare parts just to have. I have found a 1981 Evinrude 85 horse that runs for $300. Are any parts interchangeable between these two motors? If so, is $300 n OK price for a 1981 motor? Thx. By the way the model #for the...
Hello, this is my first post to the forum. I recently purchased a 15 ft bass boat with a 1988 Mariner 45 outboard. The motor has not run in a while. I pulled the carbs to clean them today and ran into a problem. Behind the top carb, there is a few wires in a shield that run from under the...
