I grabbed a screenshot to help explain. The left brass part is a plug. That fits into the exhaust manifold. The piece on the right has a hole, but when it's screwed into the block enough, water stops pouring out. I had them reversed. So the plug would never seat properly and the other would...
I'm really embarrassed but since I started this thread I'll post my stupid error. My exhaust manifold plugs were leaking. I couldn't figure out why. I swapped the plug with the manifold plug that has a hole in it and that solved my issues. I swear I tried swapping them before but gave up too...
Yes! Took it to a boat mechanic. Got one at Napa
thank you. manual says 22 lbs. there is no way I can get my torque wrench in there. someone else posted hand tight, then quarter turn.
Thank you. This helps!
I see why there is confusion. Figure 9 shows the two components. I was looking for just the plug portion, 9/16 hex. I should be able to take it from here.
So sorry, but I am unable to find a 5.0 GL-F Engine Drain Petcock Part 22848 online.
I've tried all my tricks, even ChatGPT.
Any links or words of wisdom are much appreciated. I'm no mechanic, but I've never had an issue screwing a plug in.
I can get them started, but when I try to tighten...
I've used authorized dealers for 15 years. This my first year on my own. The Volvo Penta manual (5.0 GL) states to only drain it and then put the 4 peacocks and the hoses back on for the winter.
I was planning to follow a youtuber's method of pouring PG into the thermostat "housing" just as...
It's more about reassurance if more oil leaks out than wanted while trying to put the bottom screw back in. I did buy a cheap pump so the process is much easier. Thank you!!
New outboard owner/Noob question. Replaced lower gear oil according to the manual after the 10 hour breaking. in. I had issues squeezing the bottle of oil just before it poured out the top so there was air coming out in spurts. I put the plugs in and tried the process all over to ensure it was...
I'm 57 and not a mechanic. I can only go 5mph max in a 14' Smoker craft. While in idle, I can pull the spark plug wire from the bottom and it runs the same. My bottom cylinder is not firing. I swapped the sp wires by only disconnecting them from the spark plugs, then swapping. I was hoping the...