FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
I have a 1999 Volvo SX 4.3L stern drive. I have a 14.75 x 21 pitch 3 blade prop. My Rpms are too high. Rated for 4600 but running at 5000 WOT. SPEED IS GREAT. Dont pull skiers but I need to bring my RPMs down. Should I just control with throttle or do i need to change the prop. Its pretty new SS...
Are the pivot pins supposed to move when lowering or raising the Drive? Replaced my trim sensor and gauge and it works fine when rotating by hand but when installed the gauge stays in up position. I noticed the drive moves about 90 degrees but the 12 point pin only moves about 10 degrees. Are...
New trim sender 1 white 2 black. Sender works when rotate by hand. 1/4 turn from up to down. When installed on stern drive gage does not move. I noticed the hinge pin only rotates about 1/10 of a turn from up to down. Do I have a bad switch or something else wrong. Makes no sense it works when...
My trim gage was not working. I replaced trim sender. I can move sender by hand and gage moves up and down. When I install on the outdrive the gage does not move to down position. Sender moves 1/4 turn from up to down by hand. When installed the sender only moves about 1/10 turn and gage does...
