FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Quick question, I'm putting my bravo III drive back on (1999 B3 on a 7.4MPI). As far as I can see there's only 2 seals that have to be replaced. #3 and #4 on the diagram below...
Hi Guys,
This is my 2nd attempt at fixing the problem. The package is a 99 Mercruiser 7.4MPI and a Bravo III outdrive. On a 23ft searay cuddy.
Late last summer I started getting a burning smell from the engine compartment when I was running at higher RPMs (cruising at 3200revs was OK, any...
I have a 99 7.4MPI mercruiser with a bravo 3. Winterized myself last year with no problem. This year i can't find the manifold drain plugs??
I had new manifolds and risers installed in august of this year. They are mercruiser factory manifolds. The cooling hoses enter the bottom of the...
1999 Mercruiser 7.4MPI w/ Bravo III drive in a Searay 230
I've checked most of the spun coupler posts and didn't see quite what I was looking for. Here's what's happening:
I'm smelling what I think is burning rubber once i get the boat up on plane. No smoke yet. I don't notice any loss of...
So i decided to replace my impeller and housing this year as a pre-emptive strike. Haven't done it before but got a bunch of info from this board and i have the seloc manual. (1999 mercruiser 7.4L mpi/bravo 3)
pulled the pump out and opened it up. The existing one didn't look too bad so figured...
