FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Swapping ECM had no effect, so I am presuming it is good. Exposing the wire bundle hasn't revealed any problem so far. Not really sure what more to try.
it's hunting a hundred or two rpm, not consistently. I will attempt to trace the wire tomorrow if I can and report. If I can't find any problem with it can I swap the ECM with the Port one? to test. Thanks for the replies, very frustrating.
I just completely bypassed the connector, wired a direct ground and jumped purple switch wire to purple harness wire, no change. I don't think its related but is idling a little high and hunting a little, probably need an IAC.
Yes, TBI. I do have continuity from black to switch to ground. Have completely disconnected wiring harness again looking for missed ground or other connection but haven't found anything
2000 5.0 EFI w/Alpha drive
After doing a head replacement and reconnecting all the wiring Engine runs great but wont shift back into neutral. (In the water) I have verified the switch is good. (swapped it with known good one from other engine) On my other engine if press the the cutout with...
