FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
At idle I have the timing at 2 deg. ATDC as per sticker on motor.At 3000 RPM I have 8 deg. BTDC. I would like to know if this is correct,I think it should be more like 18 deg. BTDC. THANK's Mike
I am working on a 80,s 3.0L and noticed the vibration damper can be moved (slid) on the crank forward or backword. What holds the vibration damper on. is it press fitted? I do not see any bolt in center of pully. When I push it in it goes far enough that the belt does not line up exactly. The...
Is there a rule of thumb as to dia. to pitch. I have a 13 3/4 x 15 cupped prop.what would my rpms do if I went to a cupped prop 12 3/4 x 15 or say a cupped prop 12 x 17? I run a 70 hp Jonny at 5600 rpm wot on 16ft. Lund Renegade at 31mph max.
My 1985 70 hp. that I converted to mixed fuel 4 years ago is giving variations in fuel presure readings. When at idle the pressure will drop to 0 for a few seconds then jump to 1.5-2.5lbs,then it will drop to 0 and repeat. At 2500 rpm I get 4-7lbs. variation.
I would like to do away with the VRO...
I use champion QL77JC4 plugs gapped at 40th.,I am getting conflicting info from forum.Is there a service bulitin that states a change to 30th. gap?
Thank You, Mike
My 70 hp johnson has a bad hesitation when I trailer it,Also sometimes when pulling skier ect. I have 115 to 118 lbs. of compression and moter tops out at about 5600 rpm with 13 3/4 X 15 SS prop.I wonder now much help if any would a Boyeson Power Reed kit be for this motor problem?
