Scott Danforth's latest activity

Stainless + aluminum + copper alloy (brass) is a recipe for galvanic corrosion.

Did you ever get the 2-pieces of the hull separated?

I say practice a minute or two before hand. You have this

Inspect them However at 26 years, you're well past design and service life

You visually inspect the gaskets and gasket surface between the two, and you fill the manifold with acetone (seeps thru smaller cracks)...

BRP Engine Cleaner or Mercury's Engine Tuner, are 2 of the better Ring unstickers in 2 strokes. CRC gdi ivd intake valve cleaner is also...

Was about 10 years ago. Palm tree dies, so I thought WTH..... Since I have saw in hand, let's make a Tiki..... Fell the tree leaving 6'...

Unless you are carving a Tiki from a palm tree carcass in 95 degree heat. BTDT

If Manatees are going that far North, that means the water is warming up.

If you go 100 miles/day every single day, you'll have paid for the conversion in only 10 years! (Winter too, no cheating)

Fuel Burn is 0.5# of fuel per HP per hour.

Close

Ted, it's a boat..... Fuel economy is never a consideration

cheap 12 volt tach plus a cheep buck-boost. https://www.amazon.com/DROK-5-5-30V-Adjustable-Regulator-Converter/dp/B07VNDGFT6?th=1

With the puller putting tension on it. Add heat quickly, then a bit of percussive persuasion with a 5# maul