Scott Danforth's latest activity

#12 screws

A bit more progress...... 4 steps forward, 1 step back Adapter fits Engine mount bracket design needs slight trimming HTOB...

I would love to take a look if your down here sometime and bring the beer..... check your fuel pressure and float height. I normally...

Must be that all of these manufacturers have a lot of QC variance. Every carb thread ends up like this- polar opposite experience with...

a rinse with salt-away after every dip sure does help

Yeah same here I have a stack or rotors in the garage waiting for me to find a brake lathe on market place.

The only reason I tweak a holley is when I first get it to dial it in. I will swap jets, bleeds, nozzles, cams, etc. sometimes main...

I did the brakes on a friends BMW a few years ago I was doing it for free so I told him I needed 24 bucks to download the software for...

The pile is because I keep buying them for future engine builds and I swap a lot of parts The HP-950 is ready for my 7500 rpm LS build...

Check fuel pressure

I liked your old moniker better, this new one is too close to pennywise. 😁

You are retired, so you do have a lot of free time

I personally want the throttle to back off if I take my hand off it, so I prefer less friction

That is the friction screw, but that doesn't have any issue with shifting, it's only used to hold throttle where it's moved if you...

Trailer bearings are cheaper than a 12 pack