Current visitors

Home
Members

Scott Danforth's latest activity

Scott Danforth replied to the thread Rear main seal on 5.7 GXI.

you can do it without removing the pan, however its about 10x times harder. or just pull the pan, pull the adapter, remove the seal...

Apr 23, 2026
Scott Danforth reacted to Fun Times's post in the thread What is the part number for this regulator? with Like.

Because there are two of them for the marine version the regulator you found on top of the engine is more so considered to be a fuel...

Apr 23, 2026
Scott Danforth replied to the thread Support for new floor.

2# is more than enough

Apr 23, 2026
Scott Danforth replied to the thread 2002 Four Winns 214 Funship.

FourWinns simply bought a sink. They are not brand specific. Check Great Lakes Skipper Also check the RV sites, as things like sinks...

Apr 22, 2026
Scott Danforth replied to the thread 1994 cobra 3 litre overheat.

Did you get all the missing impeller parts?

Apr 22, 2026
Scott Danforth replied to the thread What is the part number for this regulator?.

the VP regulator is a GM variant of the ones used in 2001-2008 in trucks. its just a slightly higher pressure version.
Apr 22, 2026
Scott Danforth replied to the thread 8.1 gx-i hitting rev limiter.

perfect pass is used for bad drivers in ski boats that cant watch a tach, speedo, and the wake. its intended to control the throttle to...
Apr 22, 2026
Scott Danforth replied to the thread Boat transport.

good bud of mine just had a boat moved from the east coast of Florida to Sarasota. his 3 choices were pilot around the Florida...

Apr 22, 2026
Scott Danforth replied to the thread What is the part number for this regulator?.

you should see 3 bar or just shy of 45 psi from the pump.

Apr 22, 2026
Scott Danforth replied to the thread What is the part number for this regulator?.

with only 34 psi with the vac line removed from the regulator. the regulator is fine. your pump is weak

Apr 22, 2026
Scott Danforth replied to the thread Boat transport.

talk to the broker you are using. they will have recommendations. Make sure they are licensed and bonded. that way if things go awry...

Apr 22, 2026
Scott Danforth replied to the thread What is the part number for this regulator?.

Unplugging the vacuum to the regulator is the test.

Apr 22, 2026
Scott Danforth replied to the thread 1981 MerCruiser 120 tick/ squeak.

Your compression is low, and you are describing a washed out cam love I would pull the lifter cover and measure lifter movement with a...

Apr 21, 2026
Scott Danforth replied to the thread Stoked.

Not sure why you would say that. When I worked from home at a prior job during covid, I put in 65 hours a week and was 2x as efficient...

Apr 21, 2026
Scott Danforth replied to the thread New SEI drive, need a new prop..

Unless you swapped to a Voyager EST distributor, you have points. The dwell and timing is an every year thing

Apr 21, 2026

Show older items

Home
Members

Top