FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
1990 1208x90B Force 120. A while back I added a pressure and temperature gauge to help monitor my motor. I just stumbled across the threads for adding a tell-tale, but with a well functioning pressure gauge is this even necessary? Would it mess up my readings on my gauge?
The gauge works...
Hello all. I have a 1208x90B 120hp (4 blue coils and 2 blue CDI packs) Force on my 1990 Bayliner Cobra dual console. I had it out about 2 weeks ago for the first time this season and it was running great, then suddenly lost power and sounded like it was missing on a cylinder. Started pulling...
I found the little piece that goes inside the drain plug and it is mangled. Looks like whoever had it apart last wasn't careful with it, and I think it was sitting just right so that it worked properly. There is no way to get that to work.
Now the question. Is there a source for parts for...
1990 Bayliner Cobra 1804 w/ 1990 120hp force motor. It was bought new off the showroom floor and parked for 18 years until I bought it. VERY little use on this boat, if that points toward anything.
After coming back into the landing, my tilt/trim suddenly developed a problem. It would tilt...
Are there any on-board chargers out there that can run one set of charging leads on a deep cycle profile, and the other set on a standard starting battery profile? I always top off my starting battery when charging my deep cycle with the Schumacher portable I have, but I'd like a single...
Well, I picked up my new in box power gator mount today. It works great and I can't wait to get it mounted.
I'd like to mount it on MG's removable mounting plate, but want to make sure it is big enough to fit this motor before I order. I can't find anything on the net stating the overall...
I have a 1990 Bayliner Cobra dual console bass boat. The current trolling motor is a MG Pro Series 43lb which I have shortened the shaft on to fit in the original stowable mount. It takes a fair amount of time to get the trolling motor back below the deck whenever I want to move the boat, and...
