FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Hi
my trim/tilt only works in the down position. Tested switch and relays all is working. I read a post about a limit safety switch that could be a possabile problem/ if stuck, up position won't work. Is this switch down by the tilt motor or in the engine area? Boat is in the water and can't...
I have a 1969 Dixie that I have been restoring over the years. Does anyone have a trick on removing pits in aluminum? The windshield has minor pitting in it's frame and I would like to work on it without removing it from the boat.
I have a 2001 Johnson 115 J115PLSI and the left side greese fitting won't except greese. I changed the fitting and still have the problem so obviously the greese is hard inside. My question is how to free it? Can I heat it with a flame or is that not advisable? This is the fittings on the tube a...
I have a 2001 Johnson 115 hp J115PLSI and I am looking on line for a oil sending unit float switch and I am not having any luck. Does anyone know where I can find one?
should replacing the fly wheel cover on a 2001 Johnson 115 be left to a professional because of the armature and timing settings on it? I looked in the Seloc manual and there is no metion on how to go about it. Is there a tork on the covers bolts?
went to start boat and starter turned over fine then made a bad grinding noise. when I checked the engine I found that the starter bendix cover was cracked in half? what might have caused this, could engine be siezed?
