Hi,<br /><br />I recently purchased a new vro/oms pump to replace a malfunctioning pump(not pumping fuel).<br />I have 50:1 mixed in the permanent fuel tank.I was wondering if I can plug the oil side on my new pump without damage until I run out the fuel mix.I know this procedure is common but...
Hi Iboater's,<br /><br />The VRO (fuel)pump has given out on my motor.I tried it on a portable tank,same thing.You need to pump the primer bulb to keep it running otherwise it will only run about a minute(at idle) before slowing/stalling out.I know the oil side of the pump is working good.My...
Hi folks,<br /><br />I'm working on a mid to late 80's 9.9 Evinrude.I have a problem with the fuel delivery.This I'am sure of.The motor will run fine after priming the bulb for about 2 mins.Then it will rev slighty and stall out(outa gas).The primer bulb is soft(not collapsed)when this happens...
Motor runs ok with occassional miss.Has signs of water on the plugs right after running.I checked the gas tank and installed a new head gasket+torqued(replaced original).When I remove a plug and slap it on my hand I still see (noticeable) water droplets.I also noticed while the motor was running...
Hi Folks,<br /><br />I'am in the process of diagnosing my '96 Johnson 225 with a bad smoking habit.The VRO system is connected and working, although lately heavy blue smoke is the norm(even after warm up).I lost sight of the motor for a few seconds once :rolleyes: <br />Well,today I attached...
I have aquired a '65 evinrude Yachtwin 3hp.(2 cyl,longshaft).I'am having problems getting it started and keeping it running.The motor was frozen.I freed it up.First off,the compression was low(50lbs each cyl) so I replaced the piston rings (were stuck).Compression is still about 50 lbs after new...
Joe started the day early having set his alarm clock(Made in Japan) for 6am while his coffeepot(Made in China) was perking,he shaved with his electric razor(Made in Hong Kong).He put on a dress shirt(Made in Sri Lanka),designer jeans(Made in Singapore)and tennis shoes(Made in Korea).After...
Hello,<br /> I'am trying to locate two replacement coils and an impeller for a yachtwin 2cyl.Model#3533A Ser.#B5830(Belgium).Any other info like year and hp.will be appreciated as well.Thanks! :)
Hello,<br />This may belong in boat questions,not sure.I was hoping others could share their ideas's for thoroughly mixing 2 cycle oil into a large fuel tank.I'am always concerned that the oil is not mixed thoroughly enough with the gas on non-VRO systems.I have an 85 gal.below-deck tank.I would...
I'am having a problem with a stubborn driveshaft housing(mid-section).I'm trying to remove it to get access to the backside of the upper mounts(steering arm) so I can ultimately remove the pivot tube steering assmbly.It has rusted solid to the transom bracket(motor will not turn).I have a...
Calling all OMC guru's!<br />I seem to have a problem switching gears....<br />Some kind of linkage problem I suspect.Anyway,when moving the gear selector from forward to neutral,It kinda hangs up(stays in forward) before finding neutral.I have to jiggle the helm shifter a little each time.This...
Hi all,<br /> I'm still waiting on my manual so please bare/bear? with me.I noticed today a single black w/yellow tracer wire coming out of the power pack.I has a single(male) pin in the connector.I also located the female plug which is not connected.Is there some reason these are not...
