FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Engine has been running great but today overheat alarm sounded. I had run at WOT for about 20 mins, 5000 RPM, with no discernable problems. Then ran for 5-8 mins jsut past idle to get back into harbor, then turned engine off at dock. When I fired back up 5 mins later the alarm sounded...
I have a V4 Evinrude, 115 HP 2-stroke, 1983, just got it on the water. Sounds like it runs smoothly and continuously, but I'm topping out at 2100 RPM under load. When just on warm-up lever I'm getting higher than that. Before getting on the water I had replaced fuel pump and cleaned all...
I am trying to get an Evinrude V4, 115 HP, 1983 going. Fuel is getting to the plugs (wet after cranking) but no spark in any cylinders. What should I address to troubleshoot? There is one fuse in system and looks fine. Is it possible I screwed something up by turning the flywheel...
