Am I expecting to much from a 30lb. thrust trolling motor on a 18 foot bayliner? It just doesen't move it. Is there any thing I can do to make it work as an emergency motor?
I have to replace a damaged uppe:):)r bearing and short drive shaft of a 2 piece drive shaft on my Force 125.
I have the following questions:
1. Can I reuse the shims (3) as a set. I will not have to replace the pinion as it appears ok.
2. The Clymer book I have references 1990 and above shim...
I have an 1986 85 Force and are having problems at low speed in gear. Typical trolling speed is rough. The engine runs great at WOT and idles great at idle out of gear. I thought this may be caused by the mixture adjustments, however I have adjusted by the book and seem to still have the same...
