Recent content by nms

  1. N

    Intex Mariner 4 modifications and Tips

    So I managed to do what you suggested. Unfortunately the aluminum pipe I had did not fit into the mount as it was 20mm and the mount is something like 19mm. The easiest way to me was to just make a connector out of steel, which I machined with tight tolerances so there is no wobble. The other...
  2. N

    Intex Mariner 4 modifications and Tips

    a) It is the same diameter so it should fit. 2cm diameter, 2mm thickness. b) Same. A single tube means the strength changes are gradual and consistent. On top of that the tube also acts as a spring, reducing the impact of violent forces. Multiple tubes add a sort of joint, that will result in...
  3. N

    Intex Mariner 4 modifications and Tips

    The original tube has 1.4mm thickness, it is a 20mm diameter. I will replace the entire original tube with a 20mm 2mm thickness. I don't see it bending very easily as it is around 1m only of tube. I can't bend it easily by hand, so I don't see it being a problem. Do you think the tube will be...
  4. N

    Intex Mariner 4 modifications and Tips

    I'm intending on using 2mm thick 2cm diameter aluminum tube. I don't think it will bend that easily, I've used it structurally in what I would think to be more demanding applications. Do you think that's not enough? Yeah, noise is bad, but cost is good. For now I'm satisfied, plus I have the...
  5. N

    Intex Mariner 4 modifications and Tips

    The extension seems easy and effective and aluminum is basically weightless so I will definitely do that. This motor also has very cheap maintenance, and yes it's noisy and air cooled. I didn't find any water cooled options remotely within budget. You have to take into account that 2 strokes...
  6. N

    Intex Mariner 4 modifications and Tips

    Can you explain how do I do that? WIll I need to remove the oars? I have this motor, but from a reseller.
  7. N

    Intex Mariner 4 modifications and Tips

    Hello, I'm in need of advice. I purchased my Mariner 4 a while back and have a 3HP air cooled motor with it. The thing is the motor pulls the mount down. I have added a 1cm plywood board to the bottom side of the mount and have set the motor to the maximum trim. It still pushes the mount way...
See more
Top