I bought a 70 lb mg tm about a year and a half ago new from BPS and I don't have the original receipt but I'm pretty sure I sent in the warranty info and this week I lost three speeds on my motor. What can I do to get the unit fixed and is it something I can fix on own?
I have a motorguide pro series 70 lb foot controlled 24v trolling motor and it is just over a year old and the 1 2 and 4 speed have ceased to function. I replaced the rotary switch and it didn't change anything. Is the motor going out on me? Any ideas?
Hey guys I'm looking at some wake/ski boats with inboards but I'm not spending more than low twenties on a used boat. Can you guys rate them and give me some suggestions.
I have a hard time taking off with a passenger if I go full throttle the motor cavitates is this normal? I have heard of wear rings should I replace mine? How difficult is it to replace. Once taken off the machine hauls.
For my bilge pump to run I have to have the manual switch on at the console and it never shuts off. Should this boat have an automatic bilge? I'm going to replace the pump. Any info would be great.
My Nitro bilge pump has been running sluggish lately and it is a 97 I'm going to replace it but I'm not sure exactly where it is located. My boat has a massive 30+ gallon tank and three battery trays so I don't want to start digging without a good direction.
Hey guys,
I read the Ohio laws but I don't know what qualifies. I have a whistle, distress flag, new handheld flares, type 1 life jackets and a throwable. I gave away my anchor when my dad lost his so I'll have to replace that. Do I have to get a air-horn? Thanks guys. This boat is only used on...
My merc has been running great and have had no issues since early summer when I had it repaired finally. I had a complete tuneup and they did a compression test and marked 100 on every cylinder is that a percentage or reading? He said the compression was fine when he went through it. Should I be...
I have a Nitro with a 150 Merc outboard and I'd like to pull tubers can I use the transom rings on the back of the boat to tube and ski? Any pro's or con's. Will the rings pull out?
I just got my boat back from the mechanic where I had an issue with one of my temp sensors so dumping fuel into cylinders. Boat ran great today really powered out of the hole and after sitting for a while I went to take off and she died. Bulb was soft as heck and took a lot to pump hard. After...
I have a 97 Efi 150 motor idles fairly normal but when you tromp it it runs up to 2000 RPM and no further forget about getting on plane. After this occurs the bulb is soft. Is it the check valve? I just had this boat serviced and tuned up and it ran great one time out now blah. Made for a crappy...
