FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Engine over heated pulled lower end found burned out pieces seems just one side. But no indication that other valve has disintegrated but not sure I know these shutters are at the bottom of y tube. Pulled port side manifold measure 2&7/8 inch inside diameter can I drill thru y pipe and install...
1979 228 mercruiser. Replace seal and gimble bearing. Reinstalled stern drive but will not go all the way in apx 1 inch. Is it possible gimble bearing is not all the way in. I can reach in and feel a gap between the new seal bout a little less than an inch. Is the bearing supposed to be flush...
