Mc Tool's latest activity

  • M
    Mc Tool reacted to dingbat's post in the thread Spinning reels with Like Like.
    I build and repair rods and reels as a side job for the past 12 years. Build and repair 75-100 rods a year. Have restored a number of...
  • M
    Mc Tool replied to the thread Spinning reels.
    Each to their own I guess . I use 3 gram lures ( various types ) with either a soft bait clip or a small snap swivel on my ultralite...
  • M
    Mc Tool replied to the thread Spinning reels.
    Here in New Zealand we have Dada da daaa da ( trumpet fanfare ) Swivels . These are cunning little devices that stop the line...
  • M
    Mc Tool replied to the thread Spinning reels.
    :) probly just as well Penn have the nation wide parts system if they fall to bits on the job 🤣. I have 3 Penn reels now and have had...
  • M
    Mc Tool replied to the thread Strange frequency and voltage on paguro vte 4000 diesel generator *with video*.
    I dunno lots about these things but I do have a 2.5kw inverter that has an annoying qwirk , while it produces a sine wave at 50hz the...
  • M
    Mc Tool reacted to redneck joe's post in the thread Random with Like Like.
    Happy Halloween
  • M
    Mc Tool replied to the thread Reeds?.
    Dropped a cylinder ?
  • M
    Mc Tool replied to the thread 87 50HP VRO Evinrude - Could this be my problem?.
    Yeah but , Im thinkin of all the guys I have seen that just dont know how to drive a meter to its best advantage , and all the good (ish...
  • M
    Mc Tool replied to the thread Spinning reels.
    I googled one up ....looks OK too, specially if it looks to have not done much work . Pull it to bits and make sure it has the correct...
  • M
    Mc Tool reacted to redneck joe's post in the thread Spinning reels with Like Like.
    Got the ebay accepted 'offer' in today. Seller shipped it with crappy old 10lb mono. Sidestab 2000, the midsize unit, spins as...
  • M
    Mc Tool replied to the thread Random.
    Yep , remember it well , but I thought " why the hell would anyone want that for a job " , its not even that your shoulder deep in beef...
  • M
    Mc Tool reacted to redneck joe's post in the thread Random with Like Like.
  • M
    Mc Tool replied to the thread Random.
    :Dugh! some actors just grate on me , Nielsen is one , Will Farrel and Jim Carry are a couple more that will have me lurching for the...
  • M
    Mc Tool replied to the thread 87 50HP VRO Evinrude - Could this be my problem?.
    Yep , all the hundreds of thousands of peeps all over the world that use them are just wrong . :rolleyes: They are actually a very...
  • M
    Mc Tool reacted to redneck joe's post in the thread cooking with Like Like.
    Couldn't decide whether here or the random thread...
Show older items
Top