Recent content by lee515

  1. L

    7.4 repower bellows install

    I'm ready to replace the bellows and re-install the stern drive. My shop manual says to install the bellow with the word TOP on top. The new U-joint bellow is not marked. The only difference I see is two sides are rounded and the other sides have a flat spot on them. Which way is up. The old...
  2. L

    7.4 repower startup

    I got the MPI engine dropped in last weekend. I hooked everything back up, turned the key, let the fuel pump prime then started the engine. It fired right up. Turned the key to shut it down... Nothing.. it kept running, I pulled the coil wire to kill it. Tested the ignition switch and it's fine...
  3. L

    7.4 mpi alignment

    I'm new to this forum and have been reading all the post on this subject. I replaced a 7.4 gen V mercruiser with a 7.4 MPI. I also replaced the gimbal bearing and grease seal. I'm having trouble getting my newly installed 7.4 aligned. The engine went back in as expected, I used the existing...
See more
Top