Recent content by KJ47

  1. K

    Bravo 3 (2007) raw water inlet quick disconnect fittings?

    I'm in the process of doing a swivel shaft seal/shaft, bellows, intake hose etc on a 2007 350 mag/B3. On the transom and midway to the seawater pump there is what appears to be quick disconnect fittings on the red 1 1/4 hose. Black plastic with a wire retainer, I pulled off the retainer and...
  2. K

    2007 Bravo 3 gimbal bearing, no grease fitting?

    This is my first merc drive in quite a few years, last few boats had VPs. I just purchased this and was going over the drive before I put it in the water and went to grease the gimbal bearing and the hole for the grease fitting has a tamper proof torx plug screwed in it where the gimbal bearing...
  3. K

    2011 5.7 VP mineral oil for 150 hours?

    This is my first catalyst marine engine, I have read the manual that came with the boat and the VP manual as well. The VP manual doesnt mention the 20 hour service, dealer wants the boat at 20 hours, the boat manual says follow the drive/engine manual for the first service. The VP manual says...
See more
Top