Recent content by Kapt Bobby

  1. K

    93 evinrude 25HPOver Heating

    Key is in and it is the whole pump kit
  2. K

    93 evinrude 25HPOver Heating

    I have the motor in a tank . I bring it down from a half throttle to an Idle . T motor runs really nice until it gets hot after about 15 mins.Nothing was replaced but a new Dirhard battery.
  3. K

    93 evinrude 25HPOver Heating

    I have replaced the Impeller twice in a few days thinking it was bad. When I start the Motor it runs fine, water shooting out of the tell tail and all of that .then about 15 mins later no water coming out of tell tail or anywhere else,and the motor runs rough . Any ideas of what is going on and...
  4. K

    Fuel coming out of top Carb

    When I pump the Fuel Balb Fuel comes out of the top Carb PLUS Runs bad and Stalls runs Boogs down and Dies. Any Ideas what might be WRONG????
  5. K

    79 Merc 70hp Problems

    YES but I still cant find any info on how to Adjust my FLOATS . What is the GAP setting?
  6. K

    79 Merc 70hp Problems

    Why does the post that I put on at 7/5/21 say that it was put on at Aug 26 ,2018 I still need the FLOAT setting. NEVER MIND I did not have my Glasses on .That date is when I joined DUH
  7. K

    79 Merc 70hp Problems

    Does anyone know the FLOAT SETTING for this 1979 70 HP Motor????
  8. K

    1979 merc o/b fuel pump might be bad

    Rebuilt Carbs and Fuel Pump
  9. K

    79 Merc 70hp Problems

    I had Problems getting full power out of my 70hp Merc a few days ago. It sat for a year and now not hitting top end speed . It will take off and run at High speed about 20 seconds ,then die and shut off . I cleaned the Carbs and adjusted the floats to be even with the carb base .The seam on the...
  10. K

    1979 merc o/b fuel pump might be bad

    The Motor ran fine all day then on the way home it got hard to start and died when I would power it up . NOW WHAT?????
  11. K

    1979 Mercury 70hp Choke

    What is this Cable and where does it go? I thought the Choke Solenoid controlled the Choke.
  12. K

    Installing new Trigger 79 Merc 70hp

    I am installing a new Ign Trigger do I grease or lube any Moving Parts ? I lost the Barrel nut too. Where can I get one?
  13. K

    My Prop turns Tight in REVERSE left and Right.

    I have a 1979 Mercury 70HP Outboard,Since I reinstalled my L/U after Impeller replacement. when my Motor is in Reverse It turns the Motor both Right and left. When it is in Forward the Motor only Turns in the Forward Position , and in N it does not Turn .Is this Normal ?????
  14. K

    1979 Merc 70HP Reverse Cam

    I am trying to find the Right Position to put my reverse cam in. I fell out when I removed the Lower Unit to install a Water Pump and Impeller. Man this is Driving me CRAZY.
Top