The serial number is 2B509415. I'm not sure where I'm looking for the assembly diagram?
It screws into the harness which is then bolted to the motor. Even with the heavy threads it still pulls out. A good plastic to plastic adhesive might work. Epoxy?
Hello all,
Does anybody have a remedy for this (see pic)? I bought the boat/motor only 4 months ago and every time we take it out the corregated wiring conduit becomes separated from the harness and the wires/fuel lines become exposed. I have reattached it 4 or 5 times now. While I'm getting...
Hello,
I was motoring downriver today in an area I'd never been before. I was running the throttle wide open when suddenly we hit a rock pile barely submerged under the surface. It jerked the tiller out of my hand and kicked the motor up 2 notches. There was absolutely no indication it was...
So, where do I start?
First off, my engine was running poorly so I checked the fuel filter and it was horribly clogged. When I took the filter cover off, I accidentally broke the paper gasket. After realizing how old and brittle the gasket was (probably original), I decided it would be best...
I have a couple questions about the impeller/lower unit.
1. I recently changed the impeller and when I put the lower unit back on the motor and went to the lake, it was stuck in foreward. Even when I changed the switch lever over to neutral and reverse, it was still in foreward. I took the...
I am working on an old Yamaha dirtbike and know this site has some great versatile mechanics on it. SO.... I figured someone may be able to give me a general answer based on internal combustion engines. THE QUESTION: I have a valve clearance GREATER than the recomended width on both INTAKE...
I'm just curios, I rode a Honda jetski a few years ago (I think it was a 2004 or 2005 model). I want to say it was a 1200 cc engine or there abouts. Does that sound right? The boat was a 3 seater. Does anyone know the top speed of those?
I just bought my boat and the last two times I have been to the lake I have had to spend 10-15 trying to get my engine to even fire. I have had to play with the carburator and eventually Iget the engine to run. Once the engine is warm it runs great and I have no troubles starting it again if I...
I have a Evinrude Lightwin outboard motor with a folding shaft. I am looking for the year of the motor and a confirmation the motor is a 3hp.
Model #: 3602 E
Serial #: E10749
Thank you
I just took my spark arrester and fuel filter out off my 1985 3.0 mercruiser Alpha one. I was planning on cleaning the spark arrester and thought I'd ask for an opinion on what to use. Also where could I get a new fuel filter?
Thanks
I have a 16" diameter x 17p prop for my boat and would like to know what the outcome would be if I went down a inch or two in my diameter. In general, is the lower the number of pitch, the more low end power. I'm looking for something I can pull skiers out of the water easiest and have been told...
I just bought a boat with a 3.0 liter 181 mercruiser engine by GM. The day after I brought it over into my cold climate I was told you need to pull the freeze plugs on I/O's during cold weather. Me being new to I/O's didn't know anything about it but found the freeze plug and pulled it. No water...
Could anyone tell me the year of a 65 hp merc with serial # 1542972? I am looking to put it on my 1959 14 foot lonestar boat (which has a 1959 35hp johnson super seahorse on it) but I have a feeling it might be too heavy for the boat. Would anyone happen to know the approximate weight of the...