Recent content by jrhubbard

  1. J

    What are the steps to make jack plate hight simply to set

    Hey guys, on this 1990 stratos with a 1990 evinrude 150 and a six inch jack plate, this jack plate was put on the boat just before I bought it and not set, I really don't know much about jack plates or how to set them up. My question is how to do this, is their a starting point? And how high...
  2. J

    ??? Jack Plate help cont. ???

    Hey guys it's me again. I have been reading some other threads and noticed that seems everyone saying that the cavitation plate should be even and no more then a inch above the bottom of the boat, is it the keel that they are calling the bottom, this is a 1990 stratos with a 1990 evindrude 150...
  3. J

    ??? Jack plate help ???

    Hey guys, I have a 1990 stratos with a 1990 evinrude 150 this boat has a 6in jack plate. I ask sometime back about adjusting it so I did, to my understanding I was told to take it as high as possible without losing below 15pd water pressure. I adjusted it all the way up as high as the jack plate...
  4. J

    !!! Please help Vro pumps !!!

    Hey guys, I have two Vro pumps one off of a 1994 johnson 70hp model# j70elerv the Vro pump # 0435560 the other is a 1998 evinrude 50hp model# e50tslecc the Vro # 0438404. my engine is a 1990 evinrude 150hp model#ve150slesb the Vro # 0174878 that is the part number I was given when I looked this...
  5. J

    Vro pumps ?????

    Hey guys would anyone know if a Vro off of a 50hp or a 70hp engine of the same make would work on my 1990 evinrude 150, the year models of the others is a 1994 70hp and a 1998 50hp. All I'm needing to use is the fuel pump side I don't use the oil injection I premix my own.
  6. J

    !!! Jack plates !!!

    Hey guys, so I need to raise the motor as high as I can with the jack plate without losing water pressure, right and should it throw a rooster tail or I need not to worry about a rooster tail.
  7. J

    !!! Jack plate help !!!

    Hey guys, how do I Set the hight of my engine on the jack plate on my boat, its a 1990 stratos with a 150. Were do I need to start. The engine is sitting very low right now. When I tilt it up it does not take long for it to hit the cowl on the back of the boat. I've been told when I get it set...
  8. J

    Trim trouble please help

    Hey guys, on my 1990 evinrude 150 while I'm running down the lake trimming the motor up it will trim up so High and that's it. Sitting or on the trailer it will trim and tilt up ss high as I want it to what could be my problem
  9. J

    !!!! What about the pulse line. !!!!!!!

    Hey guys, thanks for the info now that I know it is possible,like I said this is a 1990 model evinrude 150 the fuel pump that is on it is pulse driven if I do away with that pump and switch it over to a electric pump do I plug the pulse line off and If I plug it off will that effect or hurt...
  10. J

    Fuel pump trouble

    Hey, my question is, I have a 1990 model evinrude 150 hp I have had lots pf trouble with the fuel pump on this outboard , I have found that the file pump is out . The reason I know this is as long as I pump the primer bulb a few times while I'm running down the lake the motor runs like a top...
See more
Top