FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
When I pull out the control handle for a fast idle, the handle seems disconnected from the throttle cable which will not move until the handle is pushed fully forward when the throttle cable moves a very small amount. This requires a little force and springs back when released. I believe that...
I have not seen anyone note this elsewhere but in casting around for a container of some kind to run our 85 HP Force I saw that the engine cover seemed to fit the bill. Turning it upside down and stuffing a sponge into the handhold and it was good to go! (Duct tape would have done a better job)...
I am resurrecting a 1988 Capri cuddy with a Force 85. I cannot get the hand control to pull out to get neutral even by inserting a screwdriver behind the spring loaded washer at the back. Any suggestions as to what is sticking and the remedy?
Appreciate any help/suggestions.