FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Doh. I miss typed the subject. Yes it is a V-4cyl. I'm replacing the head gasket from an overheat and wanted to find the length of the head bolts to see if I shold replace them. They are in good condition physically but wondering if the had stretched, etc. I have no manual to reference...
Hello all,
I thought I would ask if anyone had access to an old Evinrude manual. I have a 1966 Evinrude 60653 60 HP 4 cyl Vtwin I'm working on and I need some specifics.
Thanks ahead of time for any help.
So be sure to check your water pump impellers. This one was just a couple years old. Unless I am mistaken, my 1966 Evinrude 60653 has no tell-tale stream. I was pretty confident impeller was ok, boy was I wrong. Maybe a crappy part that I purchased. In a matter of minutes, I overheated the...
Hello all,
I need some help removing my rack steering cable. 47 years of wear caused my steeing cable to bust it's seams. I have removed the rack from under the helm and am trying to detach the cable from the outboard portion of the engine. I don't want to force anything as I don't want to...
Ok everybody,
My tilt on my OMC (HU 16C) inboard/ouboard got stuck in up position. After research and plenty of help from this site (THANK YOU!), I pulled the clutch housing apart to find bits of the worm gear shaft pins that sheared off. My question is, Can I just replace the spring pin that...
