i have 1976 18ft bass boat with a 135hp chrysler outboard,just found out that there is no compression in three cylinders and probley scored cylinder walls,have got a 1972 125hp evienrude v4 that has not been run for a frew years.if motor is good what kind of problems am i looking at in changing...
im not sure what year this is i throught it was a 1972 85 hp. but the model #chart says its a 125 hp. number is 125283R THE CHART DOES NOT SHOW THE R ITS ALSO A V4 AND SER NO. IS J03267 THANK YOU
i have just purchased a1976 tidecraft 18ft bass boat w/135 hp chrysler and would like to know some pros and cons or any other info cant seem to find much info,and ony found one picture on the whole internet,have i got some thing rare or did they only sell two of them.or did all but two...
I have a 1976 135 hp chrysler out board it has been sitting for a couple of years,i just had a new water pump installed,and new grease put in the lower unit.took it to the lake and it started right up,seemed to run fine slow ,then when i took off to get on plane.ran fine for a frew moments then...
