Recent content by Gunner357

  1. Gunner357

    Back to the same problem

    its back to the cruddy running idled great in water but when you press throttle a little bit it dies it will start right back up, If i punch it it gets up and goes then come off plain and is dies ive about had it
  2. Gunner357

    Back to the same problem

    Ok went to the lake and couldnt get the engine to run worth a dam ,idles still too hi for me at least I ran it threw the canal and it shook like the timing was off, upper end is fine 67mph GPS... So , I had a new module I bought a while ago Put it on and BAM idles perfect in gear, perfect...
  3. Gunner357

    Back to the same problem

    well the launch by me was laoded so I bought a horse trough 110 gallon and it worked pretty well was able to get the water above the side exhaust ports cold start idled right at 900-950 let it warm it hung around 950 so I put it in gear and 650-700 could keep in gear long due to the water...
  4. Gunner357

    Back to the same problem

    Correct.... I re-timed last night set IDLE TIMING to 11* which dropped the idle to 1k on the hose which I can accept the timing runs smooth threw to WOT@22* I verified that. I Sync and linked a lil diferent than from what manual says due to the fact I WONT WORK BUT NOW IT RUNS SMOOTH HAS...
  5. Gunner357

    Back to the same problem

    I'm going to retest in a few minutes I found something that may be the issue Ill post later on it.....
  6. Gunner357

    Back to the same problem

    I firmly shift there no gear grinding
  7. Gunner357

    Back to the same problem

    CDI had me mark around the flywheel when I was having issues when I changed switch boxes it was to check TDC on each cylinder and some other marks its been a while if that is what you was inquiring about its not marked from factory
  8. Gunner357

    Oil reservoir. unhook or leave hooked up and my boat leans to the right, WHY?

    You probably get a lot of take off posts I have an 85 150 xr2 with oil injection with no issues at all plus its more convenient at least for me.... the lean mine leans too but cause of my fat ass....
  9. Gunner357

    Back to the same problem

    Im not going by the service manual numbers just bt input from people that removed stabilyzer..... the flywheel is indexed do to issue earlier and was helped by CDI thx for the reply
  10. Gunner357

    Back to the same problem

    It idles around 1k in the water but hits hard when I engage that is what Im worried about... however mine is around 4* but was set at 6* cranking set.... someone told me to drop to 11* though??? not sure about that
  11. Gunner357

    Back to the same problem

    I know this the linkage is as far as it will go now.....thx for the reply
  12. Gunner357

    Back to the same problem

    carbs are closed completely verified today
  13. Gunner357

    Back to the same problem

    Yes Verified butterflies today I do have a manual.....
Top