FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
I've been reading all the ideas and suggestions about cleaning and polishing aluminum toons. After all this money and effort I would like to protect the surfaces, and avoid having to repeat the process. Does anyone have any thoughts, or experience on spraying with poly urethane to protect the...
I recently bought a boat with an 87 Johnson 70 HP . I find out now the manifold or engine silencer is missing. Does this unit serve any other
purpose except reducing noise.
I just bought a boat wiith a 87 Johnson 70HP, and it was a little hard to
start and warm up. I put a kit in the three carbs and now the idle seems
like wide open. I bought an original service manual and modified
a phillips screwdriver to adjust the low speed orofice ( this adjustment
has no...
Can anyone tell me where the lines go on a Johnson, 70 h.p. 87 from
the primer to the 3 carbs. I purchased an original service manual ,but
nothing was listed. The primer solenoid has 3 liines, one is a larger line
the same as goes to each carb. The other two are smaller and connect
to the 3...
I recently bought a boat with a Johnson 86-70 HP motor. There is a
metal tag on each carburetor. Does this mean a modification or what??
The tag indicates :
431705
MX
26 B M
Thanks for any guidance
Recent purchase motor was slow starting but seemed to run ok after starting. I put in a kit on the 3 carbs.When trying to start the motor it runs at a very high speed. I tried to adjust the low speed valve , but it did not seem to have any effect.
I was confused ( did not note exact fuel lines...
