I have a 2007 50 hp Johnson. I have lost power to both trim controls and ignition. Turn the key and nothing happens/ This happened while I was attempting to start the motor. It was turning over fine and trim worked but as it was cold, it took a few tries to get it to turn over. Then, suddenly...
I have a 2005 50 hp Johnson Outboard. After running for 10 minutes or so at high throttle the engine starts to surge and once it starts this it continues to surge violently . I have replaced all of the fuel system and lines from the tank up to and including the fuel tank. I had a mechanic look...
Ok I think I really messed up. I replaced the water pump no problem. But when putting everything back together and repositioning the lower unit the gear linkage moved around and the top linkage gear actually slid off the upper linkage shaft. Now I have no idea how to get the upper linkage and...
I just replaced my water pump impeller on a 115 hp 1998 Mariner. When reconnecting the lower unit, the gear shift linkage seemed to pop through a plastic cover plate that apparently held the shaft in place (kept from wobbling. Now water can enter freely though this hole and into the lower unit...
I am having problems with keeping this motor running after start. It starts right up but dies after about 10 seconds. Dies sharply. Here is what I have done so far:
Replaced Fuel Pump
Replaced spark plugs
Remove in line fuel filter..checked and cleaned.
checked all hoses
connected exterior fuel...
I posted this earlier but have additional information. I have 115 hp...set all winter, tried to start it up. Started pretty easily but runs about 10 to 15 seconds then stalls..everytime. I can keep pushing the choke on the ignition and it will stay running. Or I can keep squeeezing the primer...
I have 115 hp...set all winter, tried to start it up. Started pretty easily but runs about 10 to 15 seconds then stalls..everytime. I can keep pushing the choke on the ignition and it will stay running. Or I can keep squeeezing the primer bulb and it will keep running. I went ahead and replaced...