FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Model J3RETB 1993 Johnson 3 hp in wonderful condition.
Well I was moving right along in trying to set the idle just right. I had my outboard in a tank and was having some success. After having warmed up the engine I put her in gear and started the process. I had previously installed a new...
With all the knowledge I have seen presented in the various forums and the attention to detail which everyone seems to have, why have I not seen anyone recommend using dielectric grease on all electrical (spark plug) components? Please explain.
Thanks in advance,
On my 93 3 hp Johnson model #J3RETB; now that I have it running and I want to move it from neutral to forward; please tell me at what point can I shift. Is there any magic to this and if so what is it? As I mentioned in an earlier posting the indicators are pretty well worn off the tiller. I...
I seem to recall coming across a link displaying old product catalogs. The site also displayed owners manuals; not repair manuals but the small 20 page or so Owners Manual.
Please refresh my memory.
I have a Johnson 1993 3 hp Model J3RETB. Please help me with two items:
1. The tank water is turning almost black on the surface from trying to start this little engine. Probably the oil in the fuel. I have new drive fluid, new impeller and new gas filter. Also fresh gas with (red) OMC oil...
I have got my little 3 hp Johnson all ready to fire up. It starts like a champ but is revving too high. Not sure which way is up and down and stop. Indicators have worn off. Please tell me the do's and don't s.This is a 1993 3 hp. Would like to adjust settings but I want something a bit...
Was putting bottom and top together after replacing the impeller and while putting the shaft in place and the shift rod and the water tube into the grommet I noticed a little oil dripping down from the water tube. Should I be concerned? BTW, this is a 3 hp Johnson, 1993 which I recently...
I am the proud owner of a second hand outboard. This baby is in wonderful shape. I am missing the red screw-in button for the kill switch. It appears Johnson want to sell the entire assembly. All I need is the red button that screws/snaps in.
Please help me.
I need to remove the bottom front piece of the case. How do I get the Fuel shut-off / choke button off. As you know there is the top and a bottom front and back.
BTW, is this a good little engine? If you know of any reoccurring problems please identify them.
Thank you in advance.
To all you seasoned Johnson users:
Should I use my 1967 3 hp in great shape and runs like a swiss watch (and folds) or should I buy a 1991 3 hp johnson and sell the folder?
Which runs quieter and is easier to perform periodic maintenance on?
Thanks in advance,
fat boy:)
I have a very nice 1967 3 hp folding johnson. The case is kind of rough. Does anyone know of a case for a johnson where the engine is shot but the case is good?
Thanks:)
To those in the know, kindly explain the difference between a Lightwin, a Ducktwin and a Yachtwin. Do these reference only Evinrude or do they also apply to Johnson? I can understand the twin for twin cylinders.
Thanks in advance,
Fat Boy
I recently purchased a 3 hp johnson that folds and has a case. The motor is a 8 out of 10 and the case is a 4 out of ten. I don't need the folding capability. I do need a lightweight 3 or 4 hp motor for an inflatable. Should I sell this to someone who collects these very unique motors and...
