Recent content by Ezvalet

  1. E

    Removing caliper bolts

    Hah. I know. I have a set of their impact screw drivers. Crazy Smart to change them out with Allen screws. For sure
  2. E

    Removing caliper bolts

    Thank you. I might be getting close to that. It’s difficult to get a good angle on the head / because the leaf spring u bolts are right across
  3. E

    Removing caliper bolts

    Thank you. I was hoping someone would know an approximate size or even if it’s metric or not. I know a lot of the Japanese motorcycles are all metric. I really don’t use hex or Torx sockets very often. Thx again
  4. E

    Removing caliper bolts

    Thank you soo much for the advice/input. I have soaked them with PB blaster pretty good. I just didn’t know what size or type of socket was needed to remove them. I have don’t motorcycle and truck caliper/ rotors and brakes. However obviously not on a trailer yet. I will pick up a set of Allen...
  5. E

    Removing caliper bolts

    Thank you! Any idea what size is common?
  6. E

    Removing caliper bolts

    Thank you! Any idea what size is common?
  7. E

    Removing caliper bolts

    Here’s a photo.
  8. E

    Removing caliper bolts

    Sorry. I did not include this previously- Here is a photo
  9. E

    Removing caliper bolts

    Sorry about that. Good call
  10. E

    Removing caliper bolts

    Good morning. I looked through previous posts and have not been able to find what tool is needed to remove my caliper on a karavan trailer (surge brakes). Salt water destroyed the pads. :/. I tried some of the Torx sockets I had. No luck. Either I don’t have the proper size or it’s not a...
See more
Top