Recent content by Dterry84

  1. D

    drive shaft and gimbal bearing quendry

  2. D

    drive shaft and gimbal bearing quendry

    Thanks all and does any know what the inner dimension of the bearing should be? I’m measuring around 1.36 inch Best, Dan
  3. D

    drive shaft and gimbal bearing quendry

    Hi all, I am aligning my inboard using a Vevor alignment tool and also installed a new gimbal bearing. After struggling to fit the tool in through the gimbal bearing I ended up getting the tool stuck in the bearing and had to take it out. Well, come to find out the tool measures 1.37 inch and...
  4. D

    Converting 2003 suzuki DF25 to DF30

    I was told that the specs for a DF25 is the same as a DF30 and to increase HP I would require a new CDI unit. Is there anything else that I would need in order to increase HP? Best, Dan
  5. D

    Head gasket replacement

    Hi all Do I have to take off the flywheel to replace head gasket and oil pan gasket on a 2003 DF25 Suzuki outboard? Thanks, Dan
  6. D

    Head gasket replacement on 2003 25hp 3 cyl. Suzuki

    HI all Replacing a head gasket on my 25hp suzuki outboard in hopes of fixing my milky oil issue. I have never replaced a head gasket on this outboard before. Can someone layout some tips and pointers on disassembling and replacing the head gasket? I have a service manual but does not show how...
  7. D

    NS40C slipping at high speed (not the hub)

    Hi all, Same old story I took the boat out with a few friends and before I know it the engine is accelerating but the boat is going nowhere. At first I thought it was the prop so I swapped it with a new one, with no success. I also changed the clutch dog in which gave me some improvement in...
See more
Top