Recent content by Dr1532

  1. D

    twin 01 250 efi

    I was out the other day with a good chop n and noticed both motors would almost shut down when i hit hard on the wave . they did not stall and came right back. going to check out the lanyard wiring on thurs , engines are completely on the own, boat had three batteries ,combiners for all three...
  2. D

    I am looking to buy a 87 Wellcraft Coastal

    I am looking into buying a 32"ft wellcraft coastal 1987, the boat has some rot in the upwrights that hold the fuel tanks. One thning that scares is that under the hatch in the galley there are some long cracks ,I cannot figure out in how they got there. pics attached, can anyone tell me if they...
  3. D

    twin injected 0x66 250hp

    I installed twin 01 250hp, when i bought these motors , did head gaskets , pumps, installed the new 10 micron filter on the side of the blocks , new vst filters, put new 10 micron filters in line, tank has a dual pickup, motors ran flawlesly until 2 days ago as when i went to take off the...
  4. D

    instalation manual

    does any one know where i can get a instlation manual for a 01 250 ox 66.
  5. D

    yamaha wiring

    I am going to insatlle twin 01 250 hp yamahas, most of the wiring is straight forward , but there is some that is not, esp from the shifters.looking for a diagram or diagrams so I do not cook anything, was going to go individual guages but changed my mind
  6. D

    outboard value

    twin 2001 250 fuel injected yamaha guages , tanks, wiring , around 400 hours of use thanks
  7. D

    250 yamaha

    Im looking for a ball park figure on what a couple of 2001 250 efi yamahaswould be worth. they have about 400 hours, all guages ,wiring, oil tanks, Two yamaha dealers that I have talk to stated they were not worth alot of money due to there age and what they burn for fuel
  8. D

    Donzi

    Posts: 161 Member Since: 4/9/2006 Location: RI I looked at a 33' CC Donzi, It was a older hull, I noticed that at two places forward and aft of the console that there were spider cracks on the starboard and port side of the hull, the owner told me that the 33 was noted for them in the late...
  9. D

    mid 90s lohnson

    I am looking at a boat with twin 250 johnsons , wodering if these motors are any good , withthe exception of being a gas hog , it apears theses are v8 motors
  10. D

    opti ignition

    my starboard 200 opti went fluky yesterday, it started when the tach was about 100 rpms higher than the other,then it peg at 7k then spun all the way around, the volt meter went to 10 . I did not feel any warm or hot wires ,wires indicating a dead short, then the volt meter would bounce between...
  11. D

    200 optimax

    once in a while my port motor will stall and have the 4 lights flashing quickly,as well as the alarm ,I thought someone said its going into gardianmode when this happens, it seems to happen after a good long run then idle speed through the 5mph zones, it will do this 4 or 5 times then run fine...
  12. D

    optimax plugs

    does anyone know if I can use ngk# IZFR5G plugs instead of the PZFR5Fs plugs , the p stand for platuim and the I stands for iridium
  13. D

    1999 optimax

    issue with this motor since i bought it a year ago<br />passed ddt test.ok with leakdown test.check all plug wires with spark testers ok.pulled out 4 plugs out of six,alot of carbon on them.carbon in the prop.swaped out computer from other engine, no change ,motor is doggy and runs at 5200 wot...
  14. D

    200 hp optimax

    200 hp optimax my port engine is doggy compared to the starboard engine,they both idle fine ,but the tac says its running 500rpms less then the starboard engine at wot,5200 ,compared to 5700+.how much of a varible is exceptable?also when you punch it it seems flat comparred to the right side...
See more
Top