Recent content by dogmam

  1. D

    carb help on mercury xr6 150

    jimmbo, thanks for all your help i think i got it fixed there was 2 ground wires going to the control module I tighten them up and it seems to be running a lot better
  2. D

    carb help on mercury xr6 150

    So mine don't have a switch box it's a controll mod I unplugged it no change so now im looking at the trigger and I see it has been replaced in 2021 so I will see what it checks out
  3. D

    carb help on mercury xr6 150

    sorry
  4. D

    carb help on mercury xr6 150

  5. D

    carb help on mercury xr6 150

    It's a 2002 whats your email
  6. D

    carb help on mercury xr6 150

    i will get one and check it do you think it could be my ignition controller that might be going bad
  7. D

    carb help on mercury xr6 150

    I took the coil packs off the bad side and put them on the other side they ran fine
  8. D

    carb help on mercury xr6 150

    I just got it in March the guy i got it from said he only had it out a few times the boat is like new it runs good at wot I did the testing on muffs not on the water
  9. D

    carb help on mercury xr6 150

    Hi i have a question about my motor I rebuilt the carbs and put in new carbon fiber reed valves from CCMS i was having idle problems now when I unplug spark plugs 2,4,6 and start the motor it runs fine and i can adjust the idle screw but when i unplug 1,3,5 and have 2,4,6 plugged up its hard to...
  10. D

    Hesitation at wot help

    Chris i got the hesitation out the only thing I did was put my old factory reeds back in and one I had to sand to get flat so the reeds would seat took it out no hesitation at wot now the thing you called a voltage regulator i disconnect it from the stator it would not start so I went to one I...
  11. D

    Hesitation at wot help

    Chris thanks for all your help I am thinking it has too electrical I have taken the carbs off 3 times to check floats there are all level when you turn the upside down, I flushed all the jets and blow them out with air everything seems to be clean the reed valves all look good i have not found...
  12. D

    Hesitation at wot help

    thanks i will give it a try
  13. D

    Hesitation at wot help

    I had a mechanic look at it first he said compression was fine ser#OT589198 for the link and sync i got off YouTube and the then the manual and yes I use quick silver parts all choke plates are closed
  14. D

    Hesitation at wot help

    I have done that if have went out as far as 3 turns still hesitation at wot
  15. D

    Hesitation at wot help

    Its a 2002 motor i did read that if the reeds are not seated on the rubber it will idle and my problem of hesitation at wot but I am seeing so many different things on this i am not sure what way to go i think im got to pull reeds sand down the rubber and get the reeds seated and reinstall and...
See more
Top