Just double checking, I decided to rebuild the carbs on my 2 Evinrude motors, one is I think a 1986 4hp motor, the other is a 1976 15hp motor. I'm HALF way guessing on the exact years but looking on I boats store it really don't matter as the kits are pretty much generic for most of the years...
I rebuilt the carbs this weekend on my 1990 Johnson 100GT outboard. Everything went fine and got it back together without ANY problems "which is a first in my book!" I started the motor and all seemed right with the world. BUT after I shut the engine down I squeezed the primer ball a few...
Just have a dumb question as a non mechanic. My 1990 Johnson 100hp has been running rough at idle speeds, I replaced the thermostats which did not help, and ordered carb kits which will be in by the weekend. After I did the thermostats I figured I would check to make sure all the wires were...
Hey,
I decided I'm going to go ahead and rebuild the carbs on my 1990 Johnson 100GT outboard. To be honest I haven'nt looked at the motor but I'm pretty sure it has two 2 barrel carbs on it. If this is correct do I need to buy 2 carb kits or does one kit come with everything I need for the...
Good morning, I have a 1990 Johnson 100 outboard. The engine runs great when warm. It runs rough at idle when cold, but once you take off you don't have a bit of a problem till hitting no wake zones, and after running at a slow no wake speed for 5 or 10 minutes it starts running a little...
Good Morning,
I have a 1990 Johnson GT100 Outboard. I'm having a little bit of a problem, it seems to be really cold starting when it starts up If I rev the engine with the neutral idle ajuster lever it starts to run good but as soon as I lower the rpms and try to take off it sputters. Just...
